Видео

Thank you for making this video! Super helpful!

I just installed this seat on my 2020 Iron 1200. I have been suffering too long. $410.00 now 8/24.

where can I buy it? I have a 1250 GSA 2019 thanks

Is yours the EU Approved version?

That looks super fun!

The best upgrade I gave to my 2018 GSA, often touring in Austrian Alps, where the police is very keen and enforce excessive exhaust noise, , I could adjust at my pleasure, and enjoy the throaty sound and burps/farts up and downshifting while maintaining a very low profile less intrusive while riding into small Tyrolean villages, do strongly suggest the upgrade, BTW the exhaust come with an EU certificate of approval in digital and card format that can be shown to whoever will be challenging the installation, apart that on my triple black the black finish with carbon fiber and milled steel tip end looks really fancy!

Q-mount is a scam website now!!! Do not order from them. I didn't receive my package and they don't answer my emails. I posted a comment on their Facebook ad and they blocked me from their page and deleted the comment. On Trustpilot there are a lot of similar negative comments, which I didn't check before I order.

Here's an actual test with valid sample sizes, eliminating as many possible variables as possible, being a daily commuter. Curious now how the Dunlop Road Smart 4s compare. Or even Continental Road Attack 4's.

I use it in hot weather, it's hot but bearable

Anyone have experience that these lessen butt pain on long rides since you get to shift your position?

Great review Moshe!

Great job.

Have you tried using the chin camera on your helmet? is it good?

Ela é ruim

This is such a great video. On my CV44 carburetor, my only problem seems to be that its a bit more of a challenge to get the air fuel mixture screw adjusted right. The Yost emulsion tube appears to have a negative effect on being able to accurately find the sweet spot for it. I actually dropped from the recommended 45 pilot all the way down to a 42 pilot and set my screw to 2-3/4 turns out from a gently seated position (Blue needle middle clip). It seems to like it there. My motor is a big bore 113" Ultima El Bruto and I'm shocked to see that it even runs with a 42 pilot jet! If it didn't have the Yost kit installed there's NO WAY it would. I might try to swing by a local garage to see if they'd be willing to stick a sensor up my exhaust pipe and see what kind of reading they get. If im close to 14.7 afr I'll be happy. The bike pulls like a freight train and plugs are on the lean side but as everyone knows Evos run STRONG in a lean condition. It's also been a challenge getting this carburetor dialed in due to a change of the seasons up north. As temperatures increase so does the humidity which causes motors to run on the richer side. Thank God it's been in the 70s-80s. That's allowed me to get it in tune and I can finally stop tinkering with this thing and RIDE IT!! Sorry for the longest post ever but I consider myself a master tuner of CV's and I'm 100% convinced a Yost kit is the best thing since the invention of the bread slicer and toaster, LOVE IT!!! 👍🏼🇺🇸

2:20 how did you drop the engine? Just remove one of the bolts?

Excellent video and review...

I ordered. EU. The site says 5-10 days delivery. But I don't get any tracking information nor responses on my mails. Did I get scammed?

press the rear break when revving.

Patiently waiting for a mid life update as I am nearing a tire change (2005 R1200RT). Love your unbiased reviews.

What would be the purpose of doing this adjustment?

every time i'm in the market for a piece of kit, i always check what you think first

Thanks for your insights on Mustang seat comfort.

Stock gearing?

Wow I love the details you’re able to provide! This is exactly what I was looking for. I just picked up my first Harley it is my 2nd bike. A 2014 sportster 48 (1st bike is a 2022 Yamaha MT-10). I absolutely love the bike! But after an 1:30 minutes I’m feelin it in all of the wrong ways and want to enjoy riding the bike more. I am going to give this seat a closer look thanks to your review! Thank you so much! 🙏🏻

Thanks for your review, i never knew tyre technology had become so complicated.

Love it ! Get some elf pegs on that baby so you can stretch out

I have a similar Remus. I barely noticed a difference until I removed the quiet baffle, But even then it wasn’t that loud. Reminds me of a Cessna. I’ll probably put the stock back on and sell the Remus.

My harleys never would run right with this yost power tubes had to take them back out put the stock ones back in so in the trash can the yost junk went.

Those screw are JIS screws ( Japanese industry standard) identified by the dot on the head not Phillips, that's why they chew up if you use Pozi or Phillips screwdrivers!!!

What about the ankle protection?

It's expensive, but when you consider armour, airbag and jacket are all integrated into one, I think it makes a great deal.

Very insightful, thank you very much. I have a Kawasaki Z1000SX (aka Ninja 1000SX) and have got about 10,000 miles from a Metzeler Z8 and the same from the replacement Pirelli Angel GT2. I'm now researching a replacement for those and considering the Roadsmart IV (very expensive in the UK right now!) or a better value Michelin Pilot 4 Lots to think about...

I don't know why I bothered watching this 4 days AFTER I ordered my tires but I ordered RoadSmart 3s to replace a low mileage but 17 year old set of Bridgestones and looks like I should be satisfied.

What size are you wearing and how tall are you?

If you have trouble getting the diaphragm back in the groove, put the diaphragm in freezer for about 3 to 5 minutes. It will shrink it making it easier to get back in the groove.

That rear Michelin 4GT would definatley go for at least 3000miles!!! My Front Continental lasted for 19100km, vs Rears which lasted Continental 9800km and Pirelli Diablo II 9300. Now I have a set of Dunlop SS Mk3. Let's see how it goes... I'm an easy rider on an R1. Thanks for the review mate...

Howdy, I searched for the promised update on the Sumo gloves but haven't seen anything. Have they held up ok?

Bonjour, j’aimerais savoir si l’on peut mettre en complément. La ligne akrapovic ou la gpr ? Il n’y aura aucun problème pour la coupler avec le silencieux dr jekill ? Merci pour votre réponse .

Whats that blue stuff you are putting on the intake manifold?

Did you like the this one better then the peoples pipe?

What pipe did you like better this on or the crack pipe?

I have had Darlas (amber) and Ericas (clear) on my KTM SA and a Ducati Mulitrada. They are great!

Thank you for reviewing these pants!

Interesting findings, watched both videos. I have Roadsmart III in front on my r1100s and with 10'000km or 6250 miles, it's completely worn out, nearly as bad as yours. Usually my front lasts two rear tires, but now it's more like 0,8 rear ? My michelins Pilot 1 & 3 lasted twice as long. (Same bike)

Thank you Moshe! I'm in the market for some new riding jeans/pants.

People that don't understand this topic are either the young ,and or , newer riders , and that's a shame . It's gone and never coming back . We are living in P.T. Barnum's dream world ! In my 55yrs. of 'no gap '' riding , (and still riding ) have seen big changes , and most are not good .

Nice concise instructions. Good tips, for easier reassembly, and great tip on replacing the standars phillips head screws, with the stainless hex head screws!

תודה משה יא גבר

Just got mine and while the Velcro wrist cinch is definitely an issue, the gauntlet on mine does cinch down easily to my wrist. In the end I love my new gloves.